| Force Measurement
Fixtures and Grips |
|
|
|
Optional smooth or serrated cams
allow quick and positive clamping for cables up to to 6mm diameter.
For tests to BSI spec. BS5G178 PART 1 and equivalent international
standards. Supplied with 10/32 screw for mounting on the base plate
of the stand.
Download PDF spec sheet
| A |
Max. Cable Diameter |
Rated Up To |
TYPE |
Part No. |
| 75mm (2.95in) |
6mm (0.24mm) |
1000N |
Serrated |
ACC008-77 |
| 75mm (2.95in) |
6mm (0.24mm) |
1000N |
Smooth |
ACC008-99 |
Top
 
Special quick acting double cam
grip for rapid repeat testing of substrates for tests to BSI spec.
BS5G178 PART 1 and equivalent international standards. Supplied
with 10/32 screw for mounting on the base plate of the stand.
| A |
Max. Sample Size |
Min Material Run |
Rated Up To |
Part No. |
| 62mm (2.45in) |
2mm (0.08in) |
10mm (0.40in) |
500N |
ACC008-102 |
| 62mm (2.45in) |
5mm (0.2in) |
15mm (0.59in) |
1000N |
ACC008-01 |
Top
| Rotational Grip Receptacle |
 
Crimp termination holder for tests
to BSI spec. BS5G178 PART 1 and equivalent international standards.
Adjustable for 10 sizes from 1.5mm (0.059") to 5mm (0.196").
Download PDF spec sheet
| Sample Size Diameter |
Rated Up To |
Fixing Thread |
Part No. |
| 0.059" - 0.196" |
1000N |
10/32 UNF & 15/16 UNC |
432-379 |
Top
| Adjustable Spring Receptacle |
 
Used to accurately test flexible
springs with a high length to diameter ratio. The three support
columns locate on either the I/D (inner diameter) or O/D (outer
diameter) of the spring. This prevents concave or convex movement
thereby maintaining accuracy of results. Supplied complete with
dedicated 50mm compression plate (nickel plated).
This fixture must be used with
the long extension 49755-0921 and cannot be used on MDD/P or LCP
test stands due to reduced height.
| I/D Max. |
O/D Min |
A Max |
B Ø |
Fixing Thread |
Part No. |
| 45mm (1.77in) |
8mm (0.31in) |
131.7mm (5.19in) |
50mm (1.97in) |
10/32 UNF |
ACC008-25 |
Top
 
The carriage of the peel table
is directly driven by the movement of the test stand crosshead so
maintaining an accurate 90° peel throughout the test cycle and
removing any friction effect on the resultant force reading.
Also required:
Grips for holding sample to mounting
plate of peel table - see grips for holding lids/materials.
Designed for use with MultiTest motorized
test stands.
Download PDF spec sheet
| A |
B |
C |
Part No. |
| 300mm (11.8in) |
125mm (4.92in) |
75mm (2.95in) |
ACC008-208 |
Top
|
